Simlab Conditional Displacement Control
QinHe_321
Altair Community Member
How to design a plate with displacement control in following logic:
Add 0.2m/s velocity if resistance force is lower than F (initial value 50N).
If F is not enough, add 50N to F and cycle again.
End all if total displacement reach 0.8m.
Using optistruct explict solver.
Tagged:
0
Best Answer
-
Currently there's no way to accomplish this automatically. You would need to run iteratively and adjust, or create a study inside HyperStudy to adjust your model.
0
Altair EmployeeAnswers
-
Currently there's no way to accomplish this automatically. You would need to run iteratively and adjust, or create a study inside HyperStudy to adjust your model.
0