can i show my decision tree model from forward selection operator?

michelleprizcillya
michelleprizcillya New Altair Community Member
edited November 2024 in Community Q&A
hi, i'm working on my thesis and it need to show the decision tree model. in forward selection operator it only have three output, it contains example set, attribute weights and perfomance. is there any techniques that i can try to show the model output? thank you
Tagged:

Best Answer

  • lionelderkrikor
    lionelderkrikor New Altair Community Member
    Answer ✓
    Hi @ michelleprizcillya,

    Yo can use the Remember/recall operators to extract the mod output from the Forward Selection operator.

    See the process in attached file to understand.

    Regards,

    Lionel

Answers

  • Telcontar120
    Telcontar120 New Altair Community Member
    You just need to connect the "mod" port output at the end and it will show the model both graphically and in rule form.
  • michelleprizcillya
    michelleprizcillya New Altair Community Member
    Sorry but i can not connect the port because in forward selection operator there’s no way to connect the “mod” to the “per” port ouput 
  • lionelderkrikor
    lionelderkrikor New Altair Community Member
    Answer ✓
    Hi @ michelleprizcillya,

    Yo can use the Remember/recall operators to extract the mod output from the Forward Selection operator.

    See the process in attached file to understand.

    Regards,

    Lionel

Categories