Rapid lab, problems in the simulation section

VICTOR1987
VICTOR1987 New Altair Community Member
edited November 2024 in Community Q&A
I Actually have the rapidlab software, by the moment I have a problem in the simulation step.   When I click on the Simulate button the next warning appears "Simulaiton failed: The average step size was not properly calculated The step size is 0 s or 0ms, respectively" Has anybody seen this problem?
Tagged:

Answers

  • Marco_Boeck
    Marco_Boeck New Altair Community Member
    Hi,

    Where did you find that?! That product has been discontinued for about 8 years ;)
    You may want to look into the Auto Model component however, which is up to date and there is also model simulation available.

    Regards,
    Marco

Categories