UNITS AND results of the MODEL pos processing

Leonardo Panicali Carlech
Leonardo Panicali Carlech Altair Community Member
edited June 2021 in Community Q&A

Hello,     

Question 1:

 In HM, where is the option to set units like kg-m-s etc. before starting the analysis ?

 

 

Question 2:

I have tried to finish a FEM model in the HM, but the Solver Radioss identified the following mistake, as such: Attachments;

According the results of posprocessing of my model in HM, the measurements of components would be in meters, by example. I did during the modeling how the measurements in mm. Is It right?

 

I am sending my model.hm to checking.

 

Best Regards!

 

Leo

 

- 

 

 

Tagged:

Answers

  • Q.Nguyen-Dai
    Q.Nguyen-Dai Altair Community Member
    edited June 2021

    User is only responsible for UNIT in any FE analysis. Have a look at "Unit consistency":

    image

  • Leonardo Panicali Carlech
    Leonardo Panicali Carlech Altair Community Member
    edited June 2021

    Please,

    The question 2 wasn't replied.

    I sent may model.hm to check it!

    Question 2:

    I have tried to finish a FEM model in the HM, but the Solver Radioss identified the following mistake, as such: Attachments;

    According the results of posprocessing of my model in HM, the measurements of components would be in meters, by example. I did during the modeling how the measurements in mm. Is It right?

     

    I am sending my model.hm to checking.

     

    Best Regards!

     

    Leo

     

  • Adriano A. Koga
    Adriano A. Koga
    Altair Employee
    edited June 2021
    Leonardo Panicali Carlech said:

    Please,

    The question 2 wasn't replied.

    I sent may model.hm to check it!

    Question 2:

    I have tried to finish a FEM model in the HM, but the Solver Radioss identified the following mistake, as such: Attachments;

    According the results of posprocessing of my model in HM, the measurements of components would be in meters, by example. I did during the modeling how the measurements in mm. Is It right?

     

    I am sending my model.hm to checking.

     

    Best Regards!

     

    Leo

     

    there's something wrong with your material #2, as showed in your .out file.

    Your material named PolyUMod_BB is really strange, and it is marked as 'UNSUPPORTED'.

    Please take a look at it.

     

    image

     

  • Leonardo Panicali Carlech
    Leonardo Panicali Carlech Altair Community Member
    edited June 2021
    Adriano A. Koga_21884 said:

    there's something wrong with your material #2, as showed in your .out file.

    Your material named PolyUMod_BB is really strange, and it is marked as 'UNSUPPORTED'.

    Please take a look at it.

     

    image

     

    Thank You for your comment, but:

     

    I have used PolyUmod materials together with Radioss 2021 using HyperMesh. Because of this use the material was selected as: MAT_UNSUPPORTED
     
    ....Number of dataline: 25 and etc...
     
    image

Categories