I can't find TABLED1 in loadcollector (HyperMesh 2020.1 - Optistruct)

Junghwan Oh

I'm trying to follow tutorials of  <Linear Transient Heat Transfer Analysis of an Extended Surface Heat Transfer Fin>.

In tutorial I need to build a load collector with card image of TABLED1.

However, I can't find TABLED1 in load collector. 

Is there any solution to make TABLEd1? 

Viraj Kulkarni_21218

In the 2020 version the Tabled1 entry is moved to curves instead of load collector.

So in model browser you can right click and create curve, then select tabled1.

Other option which I prefer is also to just to a Ctrl+F (opens a search bar on top right) and type tabled1 and press enter. It automatically creates tabled1 curve.

Adriano Koga_20259

Viraj Kulkarni_21218 said:

In the 2020 version the Tabled1 entry is moved to curves instead of load collector.

So in model browser you can right click and create curve, then select tabled1.

Other option which I prefer is also to just to a Ctrl+F (opens a search bar on top right) and type tabled1 and press enter. It automatically creates tabled1 curve.

Prithvi_Raj

This was very helpful but how do i add more rows into my table now ? 

there is no option for the table

PrasannaK

Prithvi_Raj said:

This was very helpful but how do i add more rows into my table now ? 

there is no option for the table

Hi Prithvi_Raj, 

Right Click on the curve so formed and then click on Edit, following window will pop up where you can add more rows.

Thank You! 

Diogo Vitorino

Right-click on "TABLED1" and select "Edit". A new window should appear. Now, either fill the first line of the table and press enter or right-click on the table and select "Add rows".