Set up RADIOSS starter to read *.sta file

JM Desrosiers

Hi,

 

I'm trying to use initial stresses in my second simulation using *.sta file, but when I follow these instructions (see attached word file), it's not working. When I delete the nodes in the 0000.rad file that are duplicated in the *.sta file,  it's not working. And when i don't delete them, I got a message saying that nodes are duplicated. These are my files. In these, I didn't delete the nodes (part: liners).

 

Note: I use 0005.sta using # include modele_repos_v6_0005.sta in the 0000.rad

 

Thanks!

 

JM

 

 

 

 

 

Altair Forum User

Hi JM,

In the .sta (modele_repos_v6_0005.sta) file there are no initial stresses written in the file. Use /STATE/BRICK/STRESS/FULL to write the stress state for the required part.

Then map the results in the model (liners).