How to set-up EDEM to automatically run another simulation after finishing another simulation

MG00222

Hello Experts,

I was wondering if EDEM can be set up to run another simulation automatically after finishing one. This would be very helpful, especially when you're away from your computer, and a remote desktop is not possible. 

OS: Windows 11

EDEM: 2024

CPU: Ryzen 9 7950x3d

GPU: 2 RTX A4000

Thanks,

jerrinjobs

Hi MG

Please take a look at this tutorial: https://community.altair.com/community/en/edem-tutorial-10-material-calibration-and-batch-mode-simulations-using-edem?id=kb_article&sysparm_article=KB0037196

I think this is exactly what you are looking for. It shows how to run jobs consecutively.

Hope this helps.

Thanks,
Jerrin Job

 

jerrinjobs

Hi MG

Please take a look at this tutorial: https://community.altair.com/community/en/edem-tutorial-10-material-calibration-and-batch-mode-simulations-using-edem?id=kb_article&sysparm_article=KB0037196

I think this is exactly what you are looking for. It shows how to run jobs consecutively.

Hope this helps.

Thanks,
Jerrin Job

 

MG00222

Jerrin Job Sibychan said:

Hi MG

Please take a look at this tutorial: https://community.altair.com/community/en/edem-tutorial-10-material-calibration-and-batch-mode-simulations-using-edem?id=kb_article&sysparm_article=KB0037196

I think this is exactly what you are looking for. It shows how to run jobs consecutively.

Hope this helps.

Thanks,
Jerrin Job

 

Thank you so much!