Reading Grid Point Stress Data using Tcl

hi,

you can file relevant commands in hyperworks destop reference guide

<?xml version="1.0" encoding="UTF-8"?>

Thanks Tinh,

I got off to to a start with help of Hyperworks help !!.

I was looking for any particular tutorial where results are extracted from the model .I am stuck with the Hyperview Hierarchy  sequence !!

Hi

Try looking in hw scripts exchange

Hello Tinh,

 Coming back to forum after couple of months!!

I am facing difficulty using the SetDataType command in the ContourCtrl  class of Hyperview 

Though I can set the query to Displacement, Grid Point Stresses(Prop 1),etc but I am not able to  choose  sub options like  Mag,X,Y,Z and Von Mises ,Signed VonMises, respectively.How do I do it ?

Your help is very much appreciated !!

Thanks and Regards,

Girish

Hi, 

use SetDataComponent command

Yes it works !! 

With respect to the Hyperview help on Tcl/TK Classes , the description on SetDataComponent is a bit misleading. It says the options can be either node,line,shell or solid.

Can  you elaborate  on the following classes(with significance to displaying a contour plot) :

1. SetDataComponent

2.SetShellLayer

3. SetDimensionEnabled 

Yes, hw help has some mistake while explaining functions

I do not ever use above functions, I just guess.

so SetDataComponent => will set component of DataType, example: DataType=Displacement, DataComponent=X

it's better for you to try some values, and then look for any affect

Hello tinh,

Greetings !!

      I intend to read  all the labels of the entity sets available in a HyperView Model file. How should I do it ?

I tried using GetSelectionSetHandle command, but it requires that I get the handle for each set then read the label .

Something similar to GetSelectionSetList  will be helpful or any other method ?

Regards,

Girish

Yes, do a loop through all sets, get handle and label of each one and append it to a list

finally print this list of all labels