Meshing stuck at 0.08%

Anthony Little_20711
Anthony Little_20711 New Altair Community Member
edited June 2021 in Community Q&A

I have tried to run a filling and solification simulation on a model and the meshing gets stuck at 0.08%. I have played around with the element size and tried using a different model. I've even tried a model that has previously worked. This issue has only occured in the last week.

Tagged:

Answers

  • Milan Pradyumanbhai Raval
    Milan Pradyumanbhai Raval
    Altair Employee
    edited June 2021

    Hello Anthony,

    This happens due to Java script failure in some system while running Inspire Cast job at local sequential stage. Change it to local parallel and it should work fine. See attached image for the reference.image

    Regards,

    Milan Raval

Categories