Load type SPC in temperature planel in hyperworks 2017
In altair tutorial it is written that
From version 2017 we can directly apply temperature with SPC load type using temperature panel (figure1 and 2)
but from temperature load, I was not able to change the load type to SPC from TEMP (figure3)
can you please help me with that?
<?xml version="1.0" encoding="UTF-8"?>
<?xml version="1.0" encoding="UTF-8"?>
<?xml version="1.0" encoding="UTF-8"?>
Answers
-
Are you using HW student edition or full version?I do see this option is available with HyperWorks Student edition 2017.2
or apply temperature by referring attached screenshot.
<?xml version="1.0" encoding="UTF-8"?>
0 -
Yes thank you a lot Rahul, You are great. I just figured it out this ways it works!
But can you please tell me why the tutorial files thermal.fem doen't get loaded to hypermesh?
<?xml version="1.0" encoding="UTF-8"?>
<?xml version="1.0" encoding="UTF-8"?>
0 -
Does it give any error while importing solver deck in the bottom of Hypermesh?
0 -
no. Just nothing happens!
0 -
can you share the thermal.fem file to check same at our end too?
0 -
Yes of course.
I downloaded it from the Tutorial models of altair optistruct
Tutorial Models - OptiStruct0 -
Share file works fine at my end.Please check the video. If still faces issue, then please let me know the version of HyperWorks you are using Student Edition or Full version?
0 -
Thanks a lot for taking the pain.
But I don't know why in my pc it doesn't work!!!
Its a full version. but license provided by the university
0 -
-
Thanks a lot for taking the pain.
But I don't know why in my pc it doesn't work!!!
Its a full version. but license provided by the university0 -
Sorry for the previous small size video. Please have a look.
If is it happening for license issue? I don't know!
0 -
Can you try copying this file in any other folder and import again? or try the file which I saved in hm and exported as fem file.
0 -
The .hm file you gave works. but not the new thermall.fem file. It still doesn't get open
0 -
Please check by importing any other .fem file.Want to know whether this is file specific issue or happening for all fem files.
Or try again after deleting setting files by referring below post.
https://community.altair.com/community?id=community_question&sys_id=044688761b2bd0908017dc61ec4bcb690 -
No .fem file works!! I don't know why
/emoticons/default_sad.png' srcset='/emoticons/sad@2x.png 2x' title=':(' width='20' />
You helped a lot really! Thank you a lot.
Can you please help me with a problem a bit?
I want to minimize thermal compliance setting volume fraction as the constraint.
I am uploading my .fem file. it says
DRESP1 1 is not referenced from within a linear heat transfer SUBCASE.
This type of response must be specified from within a linear heat transfer
SUBCASE.
This error occurs in DESOBJ 1.
As you know any .fem file isn't working I am lost a bit!
I have read your post on it. But couldn't understand the issue!
https://community.altair.com/community?id=community_question&sys_id=7f86cc3a1b2bd0908017dc61ec4bcb9d
0
