Parameterize

Mo_22586

Hi,

In regards to parameterizing the model, I have a solid piston with different fillets. I would like to parameterize the solid model so that the variables can be defined in the hyperstudy for the DOE analysis. Is it possible to parametrize any section of my interest section and then define it in the HyperStudy for further analysis?

Thanks.

Santhoshkumar

Hello,

Are you going to change the fillet radius in the HyperStudy for the DOE analysis? If so, the parameters can be defined in the CAD software. The design parameters can be imported inside SimLab and you can perform the DOE analysis by varying the radius of the fillet.

Which CAD model you have?

Please do watch the video for DOE using SimLab & HyperStudy.

SL 2510 - DOE using Altair Inspire, SimLab and HyperStudy (wistia.com)

Thanks & Regards,

Santhoshkumar

Santhoshkumar

Hello,

Are you going to change the fillet radius in the HyperStudy for the DOE analysis? If so, the parameters can be defined in the CAD software. The design parameters can be imported inside SimLab and you can perform the DOE analysis by varying the radius of the fillet.

Which CAD model you have?

Please do watch the video for DOE using SimLab & HyperStudy.

SL 2510 - DOE using Altair Inspire, SimLab and HyperStudy (wistia.com)

Thanks & Regards,

Santhoshkumar

Mo_22586

Santhoshkumar said:

Hello,

Are you going to change the fillet radius in the HyperStudy for the DOE analysis? If so, the parameters can be defined in the CAD software. The design parameters can be imported inside SimLab and you can perform the DOE analysis by varying the radius of the fillet.

Which CAD model you have?

Please do watch the video for DOE using SimLab & HyperStudy.

SL 2510 - DOE using Altair Inspire, SimLab and HyperStudy (wistia.com)

Thanks & Regards,

Santhoshkumar

Thank you. Very similar to my case, I have to work on that in this way. Thanks.