Modelling of pmsm with foc using simulink
hello,
i am using a student edition of flux for my M.Tech project. I need to co-simulate a PMSM motor with Field Oriented Control. what should i assign for the rotor kinematics for this condition. currently i am making it at imposed load and giving the parameters required by my project. but what i designed was for 5 amps rated, but in matlab it's going to 2000 amps. previously i used the simulink block for the PMSM, it worked fine. please help me with it.
i am uploading the results i got in Simulink after co-simulation.
Answers
-
Hi,
Can you try with imposed speed. in the mechancial set rotor use imposed speed and put the value of your speed.
Best regards.
0 -
Hello Abdessamed,
imposed speed i have tried. but when taken the output from link file in Matlab the values are not at all matching. but the speed remained constant. i need to run the motor from inital condition to see the changes in the current magnitudes.
0 -
If I understand you want to take into account, the load and see the starting of the motor? If it is the case, you can use “coupled load).
Best regards.
0 -
DO YOU HAVE ANY MATERIAL FOR CO-SIMULATION WITH MATLAB AND FLUX. I AM HAVING TROUBLE AS WHAT I AM MODELLING I THINK MIGHT BE WRONG.
0 -
Hi,
Unfortunately we no longer provide the examples of co simualtion between Flux and Simulink. Attacheda link shows differents steps that you need to follow to create the co simulation :
Sorry for this inconvenience.
Best regards.
0 -
Hi again,
attached to this email an example of Flux/Similink coupling.
Best regards.
0 -
thank you for the help.
have a good day abdessamed.
/emoticons/default_smile.png' srcset='/emoticons/smile@2x.png 2x' title=':)' width='20' />
0 -
You are welcome.
Best regards.
0
Altair Employee