About WinProp output file content is different

Ring

Hello, because I use Winprop to output cell.txt
I found that the output content is slightly different. How can I get the RSRQ related information And show Carries in the figure below?

 

Thanks!

 

 

Reiner_Hoppe

The syntax of the Cells.txt with the unit_impulses SNIR is:

Point coordinates x y z

followed by the sets of

antenna_number carrier_number Signal_level[dBm] SNIR [dB] for each received cell

the last set identifies the serving cell.

 

In the Cells.txt with the unit_impulses RSRQ/RSRP it is in principle the same:

Point coordinates x y z

followed by the sets of

antenna_number carrier_number RSRP [dBm] RSRQ [dB] for each received cell

the last set identifies the serving cell.

 

Alternatively you can export all the computed network planning results in ASCII files (see check box under the Network tab).

Then you will get the RSRP and RSRQ maps which can be loaded in ProMan via the result tree also as ASCII .txt files.