shell analysis
Hi,
I am trying a shell analisys of a wheel but the result is not what i expected.
I applied the force in a node, but i think the force 'stayed' just in yellow area.
Other question is how to know what intensity of force i need to apply in a shell component.
<?xml version="1.0" encoding="UTF-8"?>
<?xml version="1.0" encoding="UTF-8"?>
Find more posts tagged with
Altair EmployeeOther question is how to know what intensity of force i need to apply in a shell component.
hi,
I think this has nothing to do with Shell or solid element. The magnitude and direction of force comes from either experimental verification or experience.
Can you check whether all components are connected?
hi,
i created a contactsurf between them,but the problem now is other.
The simulation result is below
<?xml version="1.0" encoding="UTF-8"?>
<?xml version="1.0" encoding="UTF-8"?>
So what is your expectation?
could you share *.fem file?
I am planning do a optimization.
I did not found the .fem can be .out?
Altair EmployeeI couldn't see anything on out file except few autospcs.
Can you check the units, force magnitude etc..?
If possible share the model file. Please use the file transfer link in my signature to share the model file
So what is your expectation?
could you share *.fem file?