Altair RISE

A program to recognize and reward our most engaged community members

Nominate Yourself Now!

Comparator within FluxMotor - Which test needs to run?

Hello,

I have a few motors which were tested during a HyperStudy test session. I was able to save the iterations within the Motor Catalogues. I wanted to check some motor variants within FluxMotor and found the comparator. Unfortunately, most lines of the table were empty. Which test needs to run to show the data within the Comparator?

Find more posts tagged with

English

FluxMotor

v2023.0

Accepted answers

Lavanya Vadamodala_20519

Hi Melih,

You need to have the "Datasheet" test performed to get all the quantities viewed in the compare table from Motor Catalog.

Thank you,

Lavanya

All comments

Lavanya Vadamodala_20519

Hi Melih,

You need to have the "Datasheet" test performed to get all the quantities viewed in the compare table from Motor Catalog.

Thank you,

Lavanya

Melih Ayyildiz_22506

Hi Melih,

You need to have the "Datasheet" test performed to get all the quantities viewed in the compare table from Motor Catalog.

Thank you,

Lavanya

Hi Lavanya,

thank you for your response! Is it correct that the calculation is based on a FEM-based Flux model or an analytical model?

Lavanya Vadamodala_20519

Hi Lavanya,

thank you for your response! Is it correct that the calculation is based on a FEM-based Flux model or an analytical model?

Hi Melih,

It is a mix of both. FluxMotor runs a FEM-based module in Flux for the Magnetic quantities needed to complete the equivalent model. After that, FluxMotor uses an analytical model to do the tests.

Thank you,

Lavanya