Importing results from Hyperview to Hypermesh

Zbigniew Bell
Zbigniew Bell New Altair Community Member
edited March 2022 in Community Q&A

I am trying to take results from one step of a solver from Hyperview and import that step into Hypermesh in order to run a new analysis with the results of the previous simulation. Is this possible? 

If not is there a way to delay a thermal load until a time step has been met in a model?

 

Any assistance would be great! 

Thanks

Tagged:

Answers

  • PaulAltair
    PaulAltair
    Altair Employee
    edited March 2022

    If you are using Optistruct for your analysis, you could use subcases to get what you are looking for I think (i.e. perform sequential steps in the solver) rather than load in results 

    There is an example in help OS-E: 0020 Inline-4 Engine Head

    That pretensions bolts for a cylinder head then applies a thermal load

    image

Categories