Problem with EDEMCal

Unknown

Hi,

I am using EDEMCal to calibrate my DEM model. After running a bunch of simulations, I checked the results which were quite strange. After playing with the parameters strange results persisted. Finally, I have found that the frictions in "Type C Rolling Friction" have been changed to 0 (cf. the screenshot below). I think this might be a bug related to EDEMCal. Has somebody experienced something similar? or is there any solution to this?

Regards,

Ahmed

Stephen Cole

Hi Ahmed,

I see the same issue and will report to the product team for review.

As an alternative you could use the Hyperstudy-EDEM connector:

https://community.altair.com/csm?id=kb_article_view&sysparm_article=KB0119776&sys_kb_id=02c7ffc51b596d10c4dfdbd9dc4bcbc7&spa=1

Regards

Stephen

 

 

Stephen Cole

Hi Ahmed,

I see the same issue and will report to the product team for review.

As an alternative you could use the Hyperstudy-EDEM connector:

https://community.altair.com/csm?id=kb_article_view&sysparm_article=KB0119776&sys_kb_id=02c7ffc51b596d10c4dfdbd9dc4bcbc7&spa=1

Regards

Stephen

 

 

Unknown

Stephen Cole_21117 said:

Hi Ahmed,

I see the same issue and will report to the product team for review.

As an alternative you could use the Hyperstudy-EDEM connector:

https://community.altair.com/csm?id=kb_article_view&sysparm_article=KB0119776&sys_kb_id=02c7ffc51b596d10c4dfdbd9dc4bcbc7&spa=1

Regards

Stephen

 

 

Thanks, Stephen! So I will use Hyperstudy for now.