Hi,
I am trying to simulate the plate spring model in Optistruct.
Image 1- shows the spring model, its pivot end and a rigid wall
Image 2 - the line in red is the expected deformation of spring by 18.5 degree about Y axis.
image 3 - The green lines shows the required angular displacement(18.5 degree). Its measured from the wall to the free end of spring
I have specified the angular displacement value to the independent node of rb2 at the free ends of the spring.
How can i specify that the center of angular displacement as the point on wall?
<?xml version="1.0" encoding="UTF-8"?>
<?xml version="1.0" encoding="UTF-8"?>
<?xml version="1.0" encoding="UTF-8"?>
