How to generate faces for 3d mesh with only selected nodes

Akash Purushothaman
Akash Purushothaman Altair Community Member
edited October 2024 in Community Q&A

In Hypermesh, I would like to generate faces for a component. The faces must be generated for only the selected nodes

Please refer image below

image

Welcome!

It looks like you're new here. Sign in or register to get started.

Best Answer

  • PaulAltair
    PaulAltair
    Altair Employee
    edited October 2024 Answer ✓

    From General 2d Mesh Ribbon: you can create mesh 'by face' Does this do what you need?

    image

Answers

  • PaulAltair
    PaulAltair
    Altair Employee
    edited October 2024 Answer ✓

    From General 2d Mesh Ribbon: you can create mesh 'by face' Does this do what you need?

    image

  • PaulAltair
    PaulAltair
    Altair Employee
    edited May 2023

    From General 2d Mesh Ribbon: you can create mesh 'by face' Does this do what you need?

    image

    If you are using classic interface, the way I used to do it was to find faces on whole part, then either 'organise' only the elements 'by face' I need into a new comp, or if you want to just use the ^faces comp, delete elements 'by face', pick face you want, by elements 'reverse' and delete

  • Akash Purushothaman
    Akash Purushothaman Altair Community Member
    edited May 2023

    If you are using classic interface, the way I used to do it was to find faces on whole part, then either 'organise' only the elements 'by face' I need into a new comp, or if you want to just use the ^faces comp, delete elements 'by face', pick face you want, by elements 'reverse' and delete

    I understand. I am using classic interface. So I just wanted to know if there is any direct method. I will follow your suggestion. Thank you! 

Welcome!

It looks like you're new here. Sign in or register to get started.

Welcome!

It looks like you're new here. Sign in or register to get started.