Error iD:760

harshitpuri

i am trying to carry out dynamic explicit analysis while solving i am getting this message

 .. BLOCK FREE FORMAT

 .. STARTER RUNNING ON    8 THREADS
 .. CONTROL VARIABLES
 .. UNITS SYSTEM
 .. FUNCTIONS & TABLES
 .. MATERIALS
 .. NODES
 .. PROPERTIES
 .. 3D SHELL ELEMENTS
 .. 3D TRIANGULAR SHELL ELEMENTS
 .. SUBSETS
 .. ELEMENT GROUPS
 .. PART GROUPS
 .. NODE GROUP
 .. INITIAL VELOCITIES
 ** ERROR TRAPPED : REPORT TO LISTING FILE
ERROR ID :          760

 

 

in output file all i could found was this,( 962 is the last component  )

                        962,prop_ashaft                             

     RANDOM NOISE       
     ------------       
 +=============================================================+
 |     ABNORMAL END                                            |
 |          Segmentation Violation                             |
 |     TRACE BACK :                                            |
 +=============================================================+
     INITIAL VELOCITIES                                                                                                                                                                                                                                                                                                                                                                                                                                                                                             
 +=============================================================+

ERROR ID :          760
** ERROR TRAPPED

 

thanks in advance

Altair Forum User

HI,

Assign PART card image to component(s).

 

Right click on component(s) in model browser>> Edit>> Card Image>> PART and apply the changes.

 

Once done, run the job and let us know if you are through the error 

harshitpuri

I had done that but problem persists 

what to do for rigid element and admass.. i have transferred them under one collector and ticked rbody/admass with card image part .. but its not helping

Altair Forum User

Hi harsh,

 

You dont have to do that for rigids.For rigid elements do not give any PART card image. Leave it to none.

harshitpuri

Thanks Prakash but tried this too left card, prop and matid blank for comp. but problem persists.

Altair Forum User

Can you share the model file using the dropbox link in my signature below?

harshitpuri

i don't think i would be able to do that.. can you recommend major checks to be done in the file before exporting

Altair Forum User

Check the model, (card images, properties, material) etc...

check the curve definition if there is any curve and whether it is referenced or not.

 

if possible, share the entire .out file.

harshitpuri

i have send the output file with name pmi_al