Meshing/License Error
Hi. This is Phillip.
I was wondering if anyone could help me out with an error that I am having.
I am able to open the latest version of Inspire Cast just fine on my computer, and the licensing is through HyperWorks.
I usually import parasolids for my analysis.
When I press "Run" for JUST Solidification, the stage is at "Meshing", and it stays put at 0.08% under "Status".
I have seen where if I allow it to run long enough, an error message will pop up.
What could my problem be?
Answers
-
Hello Phillip,
I have seen similar issue before. Are you trying to run the model directly from any network drive? If so, I would suggest you to download it to local folder in your computer. Then try running it again. If same issue occurs again, I will try to assist you further.
Regards.
0 -
Hi Phillip,
Is it showing you any error! I would request you if you can put a snapshot so we can rectify the error and can help you in a better way. Moreover, for a big model, it may take a longer time for meshing.
Regards,
Sourav
0
Altair Employee