Direct transient analysis

Hi,
I am trying to do base excitation with 1g acceleration. But base is fixed to table, I can't assign SPCD acceleration to same nodes. So how can I set up boundary condition for base excitation.
Please suggest me solve this problem.
Thanks and regards
Narasimhamurthy
Find more posts tagged with

hi,
1G base excitation is applied with SPCD constraints in Z-direction and SPC applied on same node in all DOF as shown in below picture.
The contour result plot showed that the case is moving in Z-direction infinity.


Thank you very much,
but in base excitation we have to applied both SPC1, SPC2 and SPCD to same base
how can i apply SPC1 and SPC2 on same node.
is there any other way to setup boundary condition?
Please find attached document, here SPC1 and SPC2 are applied in different locations.
Could you share snapshot of your model with loads & boundary condition?