Feko 2022.2.1 User Manual, Section 2.12 - Repairing Mesh Parts

Terry Vogler
Terry Vogler Altair Community Member
edited February 2023 in Community Q&A

I recently upgraded to Feko 2022.2.1 and attempting to migrate older CFX models into the new version.

It does not seem that the Repairing Mesh Parts is available in this version. Is that correct?

If it is not currently available, will it be re-introduced in a future release, or is it being retired?

Tagged:

Answers

  • Terry Vogler
    Terry Vogler Altair Community Member
    edited February 2023

    I found a note in the Altair_Feko_New_CADFEKO_Interface.pdf doc that this feature will be added in a future update.

  • Torben Voigt
    Torben Voigt
    Altair Employee
    edited February 2023

    Hi @Terry Vogler , 

    I was just about to answer that the mesh repair tool are being worked on. All of the known mesh repair options are planned to be back in Feko 2022.3. However, that will still take a few weeks.

    If mesh repair is really necessary, you would have to export the mesh and import it into legacy CADFEKO until then.

     

    Best regards,
    Torben Voigt

  • Terry Vogler
    Terry Vogler Altair Community Member
    edited February 2023

    @Torben Voigt Glad to hear that. Thanks!

Categories