Error 23 - One-Step Transient Thermal Stress Analysis Tutorial

David_21774

Hi, I am solving the tutorials within the Thermal Handbook and have come across an error when solving one of the exercises. 

When solving 7.2.1 Tutorial: One-Step Transient Thermal Stress Analysis, I receive an error#23.

The output description is:

*** ERROR # 23 ***
SID 5 used on Case Control data SPC is missing in bulk data.
*** WARNING 1931: TEMP SID= 5 is not referenced by Case Control.

SID=5 is my Temperature SPC, which is created in BC>create>Temperature, this is set to 0 as specified within the tutorial. The tempSPC is later referenced in my heat loadstep and I cannot figure out why the error occurs. Is there a step/setting that I am missing? 

Adriano Koga_20259

are you sure the SPCs were created inside the loadcollector ID#5? Sometimes they could be created in a different collector by mistake. Can you double check?

Florence Maillet

Hi! Can one of you guys help me actually locate the "7.2.1 Tutorial: One-Step Transient Thermal Stress Analysis", I'm unable to find it on the Altair One page. So far I have found "RD-E: 5300 Thermal analysis" but it does not cover all the aspects of thermal analysis using Radioss (material laws for water and use of the Iform flag activated to 1). Thanks.

 

Adriano_Koga

Florence Maillet said:

Hi! Can one of you guys help me actually locate the "7.2.1 Tutorial: One-Step Transient Thermal Stress Analysis", I'm unable to find it on the Altair One page. So far I have found "RD-E: 5300 Thermal analysis" but it does not cover all the aspects of thermal analysis using Radioss (material laws for water and use of the Iform flag activated to 1). Thanks.

 

how about here?