The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
When running a motion simulation, I would like to vary the pressure on a surface by time -- I could not find a way to do this. Is it possible? Thx Bill
Hi Bill,
You cannot apply a transient pressure, let alone a static pressure, to motion bodies inside Inspire at the present time. However, this can be done in a process using MotionView and Optistruct. It is documented here in the HyperWorks Help: Tutorial on how to apply model pressure to flex body
Static image of link:
Regards,
Scott Z
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…