How to switch of automatic remeshing in HM version 2022

Karthikeyan T_21667
Karthikeyan T_21667 Altair Community Member
edited February 20 in Community Q&A

How to switch of automatic remeshing in HM version 2022

Tagged:

Answers

  • Prajval_cu
    Prajval_cu
    Altair Employee
    edited February 20

    Hi Karthikeyan,

    I hope you are looking for the Active mesh mode in General 2D mesh.

    Kindly refer the image.

     

    Regards

    Prajval

  • Karthikeyan T_21667
    Karthikeyan T_21667 Altair Community Member
    edited February 20

    Hi Prajval,

    No , The image that you have shared shows (Automatic/Interactive meshing) options, This allows us to control mesh in terms of density.

  • Prajval_cu
    Prajval_cu
    Altair Employee
    edited February 20

    KIndly go to Preferences dropdown and click on Topology revision option.

  • Prajval_cu
    Prajval_cu
    Altair Employee
    edited February 20

    PFA

  • Karthikeyan T_21667
    Karthikeyan T_21667 Altair Community Member
    edited February 20

    I have tried the same. But its not working. I have attached a video.

  • Prajval_cu
    Prajval_cu
    Altair Employee
    edited February 20
    Karthikeyan T_21667 said:

    I have tried the same. But its not working. I have attached a video.

    i couldnt able to locate any video. Try attaching it again.

  • Subhu
    Subhu Altair Community Member
    edited February 20

    try *deleteelementsmode 0 in tcl window

     

Categories