A program to recognize and reward our most engaged community members
Dear Sir,
I have a problem with the Flux motor after I put the parameter for all of motor component and then I want to simulate and see the performance but it can not simulate and the software show error as file enclosed. please advise how to solve it.
Best reagrds,
Wanwinit W.
Hi Wanwinit,
Can you share the model or warnings you are getting for this model to understand the issue?
Thank you,
Lavanya
Hi Wanwinit, Can you share the model or warnings you are getting for this model to understand the issue? Thank you, Lavanya
This model is the induction 3phase motor. and this is the first time for me using the software. I may have somethings wrong with my model. please you review it.
Best regards,
Hi Lavanya,
Please you review the file enclosed and advise.
Hi Lavanya, Please you review the file enclosed and advise. Best regards, Wanwinit W.
The issue is coming from the number of parallel paths used in the winding. It goes through any number of parallel paths except 3.
I am looking into the issue.
Thank you with your support but I cannot solve it yet. Can you make the correct model to me for trial simulate?
