No value when doing a torsional simulation

adriamrtinez
adriamrtinez Altair Community Member
edited June 27 in Community Q&A

I've been attempting a torsional simulation, but I haven't been able to obtain any displacement or stress values after multiple attempts.

I have tried adjusting the force values and laminate, but none of this worked. I also used Hypermesh 2022.3 and I had the same problem.

I have attached the .hm file below. 

Any help would be appreciated.

Tagged:

Best Answer

  • Rajashri_Saha
    Rajashri_Saha
    Altair Employee
    edited June 26 Answer ✓

    Hi Adria,

    I checked your model and found that your loads are applied to the Temp nodes and not to the structural grids.

    I updated that and now it gives displacement and stress values.

    Attached is the updated file.

    Thanks

    Rajashri

Answers

  • Rajashri_Saha
    Rajashri_Saha
    Altair Employee
    edited June 26 Answer ✓

    Hi Adria,

    I checked your model and found that your loads are applied to the Temp nodes and not to the structural grids.

    I updated that and now it gives displacement and stress values.

    Attached is the updated file.

    Thanks

    Rajashri

  • adriamrtinez
    adriamrtinez Altair Community Member
    edited June 26
    Rajashri Saha_20525 said:

    Hi Adria,

    I checked your model and found that your loads are applied to the Temp nodes and not to the structural grids.

    I updated that and now it gives displacement and stress values.

    Attached is the updated file.

    Thanks

    Rajashri

    Thanks for that. Now it works.

    Would you mind letting me know how I can deal with Temp nodes? I didn't do it on purpose.

  • Rajashri_Saha
    Rajashri_Saha
    Altair Employee
    edited June 27
    Adrià Martínez said:

    Thanks for that. Now it works.

    Would you mind letting me know how I can deal with Temp nodes? I didn't do it on purpose.

    There is no need of creating Temp nodes. You can just Delete/clear them.

    Thanks

    Rajashri

Categories