Simulation Timestep

Jake Kim_21518
Jake Kim_21518 Altair Community Member
edited June 14 in Community Q&A

 

I want to start a new simulation from this timestep is that possible? I wanted to do this because it takes a long time for the particles to generate so I want to see if there is a way for me to export the simulation shown below and start from there. How would I do this?

image

Tagged:

Best Answer

  • Stephen Cole
    Stephen Cole
    Altair Employee
    edited June 14 Answer ✓

    Hi Jake,


    If you go to the Analyst > File > Export Simulation Deck you can save the simulation at the point in time you are at in the Analyst as a new file.

    You can also reset time to 0 s so your new file starts from t=0 s however if you do this just be careful that any kinematics and factories run at the times you expect.


    Regards

    Stephen

Answers

  • Stephen Cole
    Stephen Cole
    Altair Employee
    edited June 14 Answer ✓

    Hi Jake,


    If you go to the Analyst > File > Export Simulation Deck you can save the simulation at the point in time you are at in the Analyst as a new file.

    You can also reset time to 0 s so your new file starts from t=0 s however if you do this just be careful that any kinematics and factories run at the times you expect.


    Regards

    Stephen

Categories