Snap Fit analysis
Hello '
I am doing snap fit analysis for a bottle and cap. I have an error.
ERROR ID : 183
** ERROR IN HIERARCHY (PART TO SUBSET ID)
DESCRIPTION :
-- PART ID : 1
-- PART TITLE : Bottle
REFERS TO UNEXISTING SUBSET ID=2
I refer previous queries regarding same issue. so i check /PART in component. Still issue continues.
<?xml version="1.0" encoding="UTF-8"?>
Answers
-
Hi,
Please try with the attached file.
The issue was related with the surface segment created.
0 -
Hello George,
Thank You.
Still There is another issue. I run the analysis. But run time is high and there is no animation files created.
0 -
Hi,
Try running with the engine file attached.
The model seems like there is no node selected for the imposed displacement load collector. Please recheck/review the loads defined in the model.
0 -
Hii george,
Thank you.... It works
what are the changes u have done in engine file?
0 -
Hi,
I just used a higher time step value for the run in the modified engine file.
Before imposing a time step value always check the current time step in the starter out (_0000.out) file and accordingly assign a time step value and also ensure that the mass added is also within the limit.
0 -
Altair Forum User said:
Hi,
I just used a higher time step value for the run in the modified engine file.
Before imposing a time step value always check the current time step in the starter out (_0000.out) file and accordingly assign a time step value and also ensure that the mass added is also within the limit.
how to check current time step
0 -
Hi,
Open the starter out (_0000.out) file in Textpad and find the current time step value.
<?xml version="1.0" encoding="UTF-8"?>
0
Altair Employee