Section cuts Hyperview

Leire Furundarena
Leire Furundarena Altair Community Member
edited February 2021 in Community Q&A

Hello,

I am doing a CFD simulation in hypermesh and hyperview.

When I get the results in hyperview I want to obtain the average pressure and velocity in certain sections. Imagine the pipe is 100 mm long, so I want the measures at 0mm, 20mm, 40mm, 60mm, 80mm and 100mm. It that possible? I'm trying it with different options or tutorials but I can't get the exact results.

Thanks 

Tagged:

Answers

  • Adriano Koga_20259
    Adriano Koga_20259 New Altair Community Member
    edited February 2021

    Hi,

     

    you can plot the contours at these section cuts, just by creating them.

    But as far as I know, the average of these value can't be obtained directly. At least in AcuSolve, i believe you need to create a surface in your model, and then request the averaged results. Maybe I'm wrong.

    image

  • Leire Furundarena
    Leire Furundarena Altair Community Member
    edited February 2021

    Thanks!

     

    I have created the different surfaces in hypermesh but when I launch the job, then, I cannot see the surfaces in HyperView and I cannot select the surfaces in AcuConsole (AcuOut) in order to obtain the results of different velocities and pressures What should I do?

    image

    imageimage

  • Leire Furundarena
    Leire Furundarena Altair Community Member
    edited February 2021

    I also tried to obtain values from different section cuts in Hyperview but the legend has always the same values, it doesn't addapt to the maximum and minimum of the section. Can I correct this?

Categories