Crashbox Simulation

konrad_cure
konrad_cure New Altair Community Member
edited October 2020 in Community Q&A

Hello,

 

I have modelled the crash assembly of our Formula Student Car. For the Barrier, Impact Attenuator and AIP I have followed the tutorial for Modeling and analysis of a honeycomb impact attenuator. Additionaly I have tried to model the Front Bulkhead and Support Structure. When I try to run the simulation it just says Radioss Job Complete in the solver window and does nothing more. I have provided the model and session file below. Maybe someone could point me in the right direction.

 

Best regards, and thanks beforehand,

 

Konrad

 

Unable to find an attachment - read this blog

Tagged:

Answers

  • Andy_20955
    Andy_20955 New Altair Community Member
    edited June 2020

    Hi,

    I reviewed your model and found the following issues,

     

    1) Parts #10, and 11 need to have elements in them and thus should have a PART card image and a material and property assigned to them.

    2) Their is an error with the /DT/AMS option.  We recommend using /DT/AMS mostly for quasi-static cases only so I would remove in your model.

     

    Once I fixed these two issues the model will start to run.  I noticed a few other issues looking at the model in HyperMesh.  The connectors are all yellow which means they aren't realized.  Unless you are interested in the studying the welds, I would suggest just merging the geometry and meshing it as one piece with node to node connections.    If possible, I would convert the solid tube to hex brick elements because they are more accurate then the 1st order tetra you are using.

     

    Thanks,

    Andy

     

Welcome!

It looks like you're new here. Sign in or register to get started.

Welcome!

It looks like you're new here. Sign in or register to get started.