Error 557 DRESP2 15 is not referenced above the first SUBCASE. This type of response must be specified above the first SUBCASE.

Nicolò Lodini_21379

Hello, I'm trying to set a single objective multiweighted topology optimization but I get this error, what can I do to fix it ?

 

DRESP2 15 is not referenced above the first SUBCASE.
 This type of response must be specified above the first 
 SUBCASE.
 This error occurs in DESOBJ 4.
   IN ADDITION    200 MB RAMDISK AREA WAS ALLOCATED IN MEMORY
 MAXIMUM DISK SPACE USED 

5_prova_control_arm.fem

5_prova_control_arm.out

GTT Johan

Hi Nicolo
Below is changes to your deck that will make simulation to run (edited in text editor since it seems to be hard to get all cards correct via GUI) 

So, dresp20 calls for dresp1 #id2 for subcase 3 , which in turn is used in dresp2 #id 15

I have not looked at the optimisation set-up as such!

Good luck with trying it out!

/johan

***************

DESGLB        2

DESOBJ(MIN)=15
$
$
$HMNAME LOADSTEP               3"LoadStep"       1
$
SUBCASE        3
  LABEL LoadStep
ANALYSIS STATICS
  SPC =        1
  LOAD =        4
$$--------------------------------------------------------------
$$ HYPERMESH TAGS 
$$--------------------------------------------------------------
$$BEGIN TAGS
$$END TAGS
$
BEGIN BULK
$$
$$  Stacking Information for Ply-Based Composite Definition
$$

 

$HMNAME DESVARS        1design_prop
DTPL    1       PSOLID  2       
$$
$$  OPTIRESPONSES Data
$$
DRESP1  2       disp1   DISP                        TXYZ            2699
DRESP1  6       Vol_fracVOLFRAC                                 
DRESP1  14      mass    MASS    PSOLID                                 2
DRESP2  20      DISPsub AVG
+       DRESP1L 2       3

DRESP2  15      media_pe       1        
+       DRESP1        14

+       DRESP2        20
$
$HMNAME DEQUATIONS       1Media_pesata_obiettivi
$
DEQATN  1       f(x,y)=0.1*x+0.9*y
$
$$  OPTICONSTRAINTS Data