Negligible Stress results in Rollcage Dynamic Analysis

Hello everyone, recently i did dynamic analysis for my rollcage with radios as solver but somehow the results were showing minimal stress. I have done the following steps mentioned in the photo attached. Any possible solutions would be greatly appreciated.

Find more posts tagged with

English

Radioss

Accepted answers

All comments

Adriano Koga_20259

please share more details and pictures of what you are doing so that people can assist you better.

Ali Abu Farjad

please share more details and pictures of what you are doing so that people can assist you better.

I am fairly new to this software, can you please explain what details and pictures i should provide???? then I'll do the same. Thank you for replying ????

Andy_20955

Hi,

Another possibility is to double check the units you are using in the model are correct. Are they all consistent?

Also make sure that those same units are shown in the /BEGIN statement. The units should be the same on the last two lines.

Thanks,

Andy

/BEGIN model1       2020         0                   kg                  mm                  ms                   kg                  mm                  ms