The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
How can I verify that a Fitted Spine line created in CADfeko is a 2nd derivative continuous line?
I need to make sure that ‘FittedSpline1’ in W_L_Input_2GHz_v3_0_30_mesh_45_45_Faster_solver_TUTandBody is a 2nd derivative continuous line?
I also need to 2nd derivative continuous line going from the diagonal line on the loft (‘Loft1’, L_W_R_D_d_T_t_imput_v11_2ndDervativeContunuousLine) to the ‘Bottom’ face. the ends of both lines must have the same tangent as the surfaces that they connecting to. How would I go about making the line and verify that it is a 2nd derivative continuous line?
Hello Wayne,
Have a look at the below explanation.
Regards,
Sourav
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…