Tensioning feature not activated after Belt routing.

Naresh
Naresh Altair Community Member
edited February 29 in Community Q&A

Hello,

After placing ATD on the seat, I could route the belt using manual method. But tensioning feature is not active. I have see both 2D and 1D elements and able to move the belt interactively. Only tensioning feature is not active to remove the slack. Any quick fix??

Regards,

Naresh Kini

Tagged:

Answers

  • Michael Herve_21439
    Michael Herve_21439
    Altair Employee

    Hello @Naresh ,
    were you able to fix your issue? If not, could you please open a support case with your model so that we can investigate further?

    best Regards,

    Michael

Categories