The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
I wanted to simulate various impact scenarios of buggy. Here I have created various load steps and its corrwsponding forces and spc. How can I view various subcase results in hyperview. I am attaching a screenhot if anyone can point out where to toggle between various subcases. I am also attaching the hm file for reference.Please help
for some reason your 'Results' tab is not shown. Enable it, first.
then select the loadcase.
I suggest you to go through some basic training/tutorials on HyperView if you're not familiar to it. There are a few in the Help.
for some reason your 'Results' tab is not shown. Enable it, first. then select the loadcase. I suggest you to go through some basic training/tutorials on HyperView if you're not familiar to it. There are a few in the Help.
THANKS a lot Sir I was also searching for this option itself
