Meshing failure

Justin_21195
Justin_21195 Altair Community Member
edited May 14 in Community Q&A

Hello,

I'm trying my hand at some casting simulation on the student version of Altair Inspire Cast. I followed some tutorials provided by Altair and everything seemed pretty straightforward until I began simulation. Once I click run, the meshing begins and fails, I'm not receiving any errors, just a red x. I'm hoping to do investment casting simulations on it but just starting with the basics. 

image

image

Tagged:

Answers

  • Milan Pradyumanbhai Raval
    Milan Pradyumanbhai Raval
    Altair Employee
    edited May 14

    Hi Justin,

    When you double click on that failed run, you will see some error message. If not, then there might be some issue with the geometry as the mesh is failing. Can you check the model if it is solid or missing any surface?

    Milan Raval

Categories