Structural analysis for casting part

Nancy Jewel Mcdonie
Nancy Jewel Mcdonie Altair Community Member
edited May 31 in Community Q&A

Hi all experts,

I have a question: After I run a casting simulation with Inspire Cast, can I run a structural analysis to check my part is safe or not? 

If possible, how can I do and what software of Altair can I use? 

Thank you. 

Tagged:

Answers

  • MilanRaval
    MilanRaval
    Altair Employee
    edited May 30

    Hello Nancy,

    If you are planning to run a deformation/thermomechanical analysis for stresses, you can do it within Inspire Cast itself.  For other purposes, you can use the result files generated from Inspire Cast which can be used in HyperMesh/Optistruct to do post-processing.

    Regards,

    Milan Raval

  • Nancy Jewel Mcdonie
    Nancy Jewel Mcdonie Altair Community Member
    edited May 31
    Milan Pradyumanbhai Raval said:

    Hello Nancy,

    If you are planning to run a deformation/thermomechanical analysis for stresses, you can do it within Inspire Cast itself.  For other purposes, you can use the result files generated from Inspire Cast which can be used in HyperMesh/Optistruct to do post-processing.

    Regards,

    Milan Raval

    Thank for your answer. 

    But I want to run a structural analysis for my cast part after filling to check if it is safe or not. Not post-processing. 

Categories