Macro to create LookUp Table for Flux

Sangeet Yadav

Hi All!

I m trying to use the macro "CreateLookUpTableFromTMProjectDQLight.PFM".

 

I am not able to get an Idea what has to be given in the place of (Number of pole pairs represented in geometry). and the Number of stator periodicities.

I have  a 10 Pole 12 Slot machine , which is Fractional Winding machine.
Periodicity is 2.
I have created 180degree geometry in flux.
What is meant by the points given in below image taken from the macro manual?

Can anybody help me?

Thanks,
Sangeet.

Lavanya Vadamodala_20519

Hello Sangeet,

In the periodic model on which you are trying to use the "CreateLookUpTableFromTMProjectDQLight.PFM", you need to have one pole or an integer number of pole pairs.

Since this is not possible in 12 slot/10-pole configuration, you need to have the whole motor in the model without periodicity and then use the Macro.

 

Thank you,

Lavanya

Community-Pasted-Attachment-1676668128084.png