Query about Geometry Cleanup and Meshing

2»

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited September 2017
    Altair Forum User said:

    Thank you so much. Got it.

    Hi, Could you tell me about welding joints in hypermesh? In my stress analysis two components are joint with arc welding. So, how can i mention these joints are welded in my analysis？

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited September 2017
    Altair Forum User said:

    Hi WikiJoy,

     

    There are modelling mistakes in your model.

     

    1) Nodes are not connected

    2) You may have to use tie contact or RBEs wherever it is necessary . 

     

    Run a normal modes analysis to check the connectivity or select one element (say in mask panel) and do by attached. You will get to know which elements are isolated.

     

     

    Hi, Could you tell me about welding joints in hypermesh? In my stress analysis two components are joint with arc welding. So, how can i mention these joints are welded in my analysis？

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited September 2017

    Hi WikiJoy,

     

    Use Connectors panel to create weld joints. Spot>> ACM welding        

Categories