Altair RISE

A program to recognize and reward our most engaged community members

Nominate Yourself Now!

* ERROR # 2372 * No PGASK properties exist in the bulk data.

Hi! I am trying to run an analysis of a solid model, which i have meshed using general solid map mesh and other methods (like spin, line drag, element offset). I also assigned a single property to two components shown in the model browser (Model and solid map mesh). This is error I get , please clarify.

*** ERROR # 2372 ***
No PGASK properties exist in the bulk data.
*** ERROR 14: Missing property # 1 referenced by CGASK8 # 2044897.
*** ERROR 14: Missing property # 1 referenced by CGASK8 # 2044898.
*** ERROR 14: Missing property # 1 referenced by CGASK8 # 2044899.
*** ERROR 14: Missing property # 1 referenced by CGASK8 # 2044900.
*** ERROR 14: Missing property # 1 referenced by CGASK8 # 2044901.
*** ERROR 14: Missing property # 1 referenced by CGASK8 # 2044902.
*** ERROR 14: Missing property # 1 referenced by CGASK8 # 2044903.
*** ERROR 14: Missing property # 1 referenced by CGASK8 # 2044904.

*** More of ERROR messages # 14 were suppressed...

****************
Too many error messages. Aborting run.
Current limit is 10000. Use 'MSGLMT' control card to change this value.

Find more posts tagged with

English

OptiStruct

Accepted answers

All comments

Altair Forum User

Hi Ankit,

Looks like you are using a gasket material and applied a wrong property. Please check and update the property.

Altair Forum User

Thanks for the response, I had assigned material MAT1 to the property! No gasket material was assigned , but still I am getting the same output. Could there any other reason for this

Altair Forum User

Ankith,

You are using a element type of CGASK which is used for gasket modelling. Update the element type to PSOLID.

Go to 3D page>>Element type>> select the elements>> CHange the config to as shown in the image and click UPDATE.

<?xml version="1.0" encoding="UTF-8"?>

Altair Forum User

I ran into this issue when converting from an Abaqus model to Hypermesh file. The solution above, provided by Prakash, worked for me. Thanks.

Altair Forum User

Open the .fem file in notepad/ any editable format then ctrl+H (Replace) CGASK6 with CPENTA then save the file.

Now you can run the file. actually it is just version problem in hm.