Hi, When simulating with low pressure casting, when I run it with the run command it gives a Meshing error. What should I do?
I proceeded in the same way as the video on your InspireCast page but couldn't fix the meshing issue. May you help?
Find more posts tagged with
Sort by:
1 - 3 of
31
Hello,
If you provide me your setup file(.icast) , I would investigate the cause of mesh fail.
Thank you.
I added the file.If you can fix it, can you go out to me step by step? I just started using the program.Thanks, in advance.
Hello,
If you provide me your setup file(.icast) , I would investigate the cause of mesh fail.
Thank you.
here the icast file
Hello,
If you provide me your setup file(.icast) , I would investigate the cause of mesh fail.
Thank you.