Hello,
I am using HYPERMESH 12 and working on foam core sandwich composite. Core is a non linear material where as skin is carbon/epoxy composite.
While solving my model in OPTISTRUCT i get this error msg
NOTE # 9199
MSGLMT=STRICT is active, all messages will be printed.
You can suppress some less important warning messages by use of
MSGLMT=BRIEF or UNREF (in config file or in the input data).
*** INTERNAL PROGRAMMING ERROR ***
in file 'contslv_AN.F', at location # 200.
**** ABORTING RUN DUE TO AN INTERNAL ERROR ****
Is there any connection of this error with below mentioned points-
a) When I switch on my 'traditional and 3D element representation' and 'Composite layer' i get a message at the status bar i.e. 'not able to create normal of element'. While creating the ply it didn't say that but now it is giving this error when i am switich on my plies.
/emoticons/default_cool.png' alt='B)'> Is it compulsory to maintain mesh connectivity? I had to compromise it at few curvature areas where i couldnot maintain mappability.
I can connect through Web ex if you want to see the model.
Thank you
<?xml version="1.0" encoding="UTF-8"?>
