Problem in Anchor node selection

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Hello all

 

when I want to do the Topography optimization , I encounter the problem of selecting nodes , its not possible to select the nodes , according to the tutorial I am doing , the coordinates are not known , and when I enter the value 1 or 0 or 2 , the software says , entity not found. also the constraints demonstrated in the view doesnt let me see the model appropriately

Unable to find an attachment - read this blog

Tagged:

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited November 2013

    Can u tell me in which step you have struck. 

     

     I am assuming that you are in step_2 'Setting up a topography optimization in HyperMesh'

     

    In that u have to specify a node ID where u got the maximum displacement.

    (See in page no.5 (point.6) displacement contour gives you the node ID (7373) where the maximum stress was occurred) 

Categories