Pressure-1D-Beam

tinh

Hi 9527kun

Why do you think the results are wrong?

Hi Prakash Pagadala

load in z  direction, but displacement in y direction,  do you think the results are right?

Have you changed the TYPE to FZ or FZE?

Card edit the loads and change the type to FZ or FZE and check the results.

Thanks /emoticons/default_tongue.png' alt=':P' srcset='/emoticons/tongue@2x.png 2x' width='20' height='20'>  Prakash Pagadala

where can i change the type to FZ or FZE, can you show me a Greenshot?

Unfortunately I cannot upload images /emoticons/default_sad.png' alt=':(' srcset='/emoticons/sad@2x.png 2x' width='20' height='20'>

I can guide you:

1) You should see an icon call card Edit

2) select that and change the selector type to Loads

3) change the config to Pressure and select the PLOAD1s

4) click and you should see the card.

5) in that change the type to FZ or FZE

hi  Prakash Pagadala   Unit of PLOAD1  is N/mm or N/mm^2?

thanks

it is N/mm^2

Prakash Pagadala 

but  Linear Load Unit is N/mm.

Thanks, Leslie

Yes you are right, it is a distributed load on a line in a span of length. so it is force per length.

it is N/mm. 

I take my word back and I apologize.