Retained Responses Table: DRESP1 Response Problem?

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Hi Team,

 

I am running a topology analyses in which case my model includes 2 displacement responses on the same node (one DRESP1 for y-displacement, and one DRESP1 for x-displacement). All responses can be seen in my analysis deck, but during the analysis run the Retained Responses Table only shows 1 of the responses.

 

Do I need to include an OPTICONTROL command to output more information? Or is it possible this response is not working properly?

 

Thank you very much,

Jason

 

 

Tagged:

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited February 2015

    if the response are unconstrained, the value will not come in output file by default. you need to use DREPORT card to have output of the responses.

     

    if the response is constrained, use RESPRINT card. you will get the response value in output file.

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited December 2015

    Where could I create the DREPORT card? It does not appear in Tools > Create Cards > 'C'

     

    Or should I just manually add it in the .fem file, but at which line?

     

    Kind regards,

    Robbin

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited December 2015

    Hi Robbin,

     

    Please enter the DREPORT bulk entry through BULK UNSUPPORTED CARDS manually.

Categories