workshop 4 Blower – Sliding Mesh

Altair Forum User

hello..

any one can tell me in detail how to do this process below

<?xml version="1.0" encoding="UTF-8"?>
i’m stuck in AcuSolve workshop 4 Blower – Sliding Mesh

and

I have a problem every i finishing runing acusolve transient analysis, can't open the result in AcuFieldView, always error to open it

<?xml version="1.0" encoding="UTF-8"?>

 

regards

ydigit

This 'manual' step was necessary prior to AcuSolve 12.0. This is simplified to a great extent.

 

Use AcuConsole > Tools > Project Solution.

Select the .Log file from previous workshop. See screenshot.

 

----------------------

Second issue with AcuFieldView

This typically happens in 12.0 when the initial conditions (time = time_step = 0) is written.  This issue has been fixed in HyperWorks 13.0.

 

If you want a solution with HW 12.0 then, couple of options

1. You can remove the initial conditions output set through acuDmg (or Tools > Disk Management - from AcuConsole) - expand the problem name and run number - then nodal output and delete the time step 0 set.

2. rerun the problem but first un-check the Write Initial Conditions in the Nodal Output setup.

 

3. Use AcuConsole > AcuOut > Output format = FieldView ( select other options appropriately).

 

 

 

<?xml version="1.0" encoding="UTF-8"?>