Opening model in HyperView

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Hi,

 

I used the RADIOSS version 12 software for a simulation. I tried reading the results on the downloadable student version but to no avail. It asked me 'select model reader' I tried the possibilities without results. :


Thanks,

Pierre FLANDIN

Tagged:

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited February 2017

    Hi Flandin,

    Please upload the h3d file in HyperView to view the results.

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited June 2018

    Hi there,

     

    I did a non-linear dynamic topology optimization using ESLM in Optistruct.

     

    After the optimization it is possible to open the mvw.-file directly from Optristruct, but I can not open this file later in Hyperview itsself.

    Hyperview asked me to 'Select Model Reader' and to 'Select Result Reader'´-  I tried many combination, but none worked.

     

    Can someone tell me, what I have to select there?

     

    Thanks a lot!

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited June 2018

    Hi

     

    Go to File>>Session>>point to mvw file. 

Categories