Acusolve "Workshop9 – Honey in Tea" Problem!!!!!

Altair Forum User

Hello everyone,

 

i´ve just attempt to work on 'Workshop 9 _ Honey in Tea' from the website below.

Here the link.

 

When i try to run AcuSolve after setting all parameters, the following Problem arises. Below the picture.

 

Can somebody tell me why this error-message appears?

 

Thanks

<?xml version="1.0" encoding="UTF-8"?>

cfdguru

This type of error generally appears due to some non-English characters being present in the AcuConsole database.  Can you check for these in your surface/volume group names as well as the script that you wrote for the initial conditions?

Altair Forum User

thank you for your response.

here my settings

i couldn't find any non-english characters

 

<?xml version="1.0" encoding="UTF-8"?>

<?xml version="1.0" encoding="UTF-8"?>

Altair Forum User

ok, i could find the problem. just replaced .....'...... with .......'........ in script.

 

but now i can't open AcuFieldView after calculating. Following error message appears.

does someone know why that happens?

<?xml version="1.0" encoding="UTF-8"?>

<?xml version="1.0" encoding="UTF-8"?>

<?xml version="1.0" encoding="UTF-8"?>

ydigit

This typically happens in 12.0 when the initial conditions (time = time_step = 0) is written.  This issue has been fixed in the just-released 13.0 version.

 

If you want a solution with HW 12.0 then, couple of options

1. You can remove the initial conditions output set through acuDmg (or Tools > Disk Management - from AcuConsole) - expand the problem name and run number - then nodal output and delete the time step 0 set.

2. rerun the problem but first un-check the Write Initial Conditions in the Nodal Output setup.

 

3. Use AcuConsole > AcuOut > Output format = FieldView ( select other options appropriately).

 

Altair Forum User

thank you sir

 

it works!!!